Interior trim, protected before the first scratch.

Interior plastic wears first: door cards, console surrounds, dash trim, pillar caps. SalonShield is a black textured film that takes the scratches instead of the plastic, and leaves worn panels looking factory again. Sold by the roll to shops that do the work themselves.

Request wholesale pricing See the benefits
Scratch-resistant Stretches under heat Strong adhesive Wipes clean

01 · Technical data

SalonShield — Black Textured Film PVC · 8 mil Made in Korea Sheet 01 of 01
No.PropertyValueRemark
01Composition4-layer PVCProtective top coat, print layer, base sheet, PMMA adhesive
02Thickness8 mil (0.2 mm)Manufacturer's average. A gauge run over the adhesive reads close to 10 mil
03Roll size48 in × up to 164 ftLength varies by pattern series
04Scratch resistance3HASTM D3363-05
05Adhesion10.29 N/mmKS T 1028 — peel strength after 24 h
06Abrasion15.1 mgISO 9352 — weight loss, 1,000 cycles, CS-10
07Fire ratingClass AASTM E-84 / UL 723
08Install temperature54–100 °FDry method, interior only
09Warranty5 yearsManufacturer's terms apply

Figures from the manufacturer's technical data sheet; request the full document for lot-specific values.

SalonShield black textured film roll in its shipping box

02 · What you get on the panel

Protection

Holds up to daily use

3H pencil hardness under ASTM D3363-05. 15.1 mg of wear after 1,000 abrasion cycles under ISO 9352. Ask for the full datasheet.

Application

Easy to work

It stretches under heat and keeps its texture, so it lays into curves without the pattern distorting. Overstretch it and the finish goes glossy — heat it again and the matte comes back.

Memory correction

Fewer callbacks

Heat it again and the film relaxes. That takes the tension out of edges and seams — the usual reason a job comes back.

03 · Install in one sitting

Three steps, one sitting

  1. Prep — degrease the part and dry it.
  2. Apply — peel the backing carefully and lay the film onto the part. Help it into complex contours with a heat gun, but go gently. Trim the excess with a knife.
  3. Cure & inspect — squeegee flat and check the part under raking light before you hand the car back. Full adhesion develops within 24 hours.
Hands smoothing black textured SalonShield film onto a car door panel

04 · Wholesale inquiries

Get wholesale pricing

Tell us your shop and the volume you run. We'll send pricing, sample rolls and the install guide.